Furman M8X2 Merit Series Power Conditioner
The Furman M8X2 Merit Series Power Conditioner is the perfect low-cost
AC power solution for any rack mount system. Install an M-8x2 in to the
top slot of your rack, and the eight switched outlets in the rear panel
will power up and protect all your equipment up to a 15-amp load. The
M-8x2 is designed for applications where lights are not required.
Furman M8X2 Merit Series Power Conditioner
Maximum Output Current: 15 amps
Line Cord: 6 ft., captive, 14 AWG, with 3-conductor Edison plug
Operating Voltage: 120VAC 60Hz
Spike Protection Mode: Line to neutral
Energy Dissipation: 170 joules
Peak Impulse Current: 12,000 amps
Maximum Continuous Opterating Voltage: 130 VAC RMS
Let Through Voltage (@ 125 amps, 8/20uS waveform): 400 volts
Noise Attenuation: Transverse mode: Greater than 23dB, 200Khz to 10 Mhz
Dimensions (HxWxD): 1.75 x 19 x 3.75 inches
Weight: 4.9 lbs.
Safety Agency Listing: cTUVus
Warranty:
Merit Series units are protected by a limited three year warranty
covering defects in materials and workmanship.
|
Connect with us